Norton’s Theorem

Engineering world
0

 NORTON’S   THEOREM:

 

Norton’s theorem   states   the   following:

Any two-terminal linear bilateral dc network can be replaced by an equivalent circuit consisting of a current and a parallel resistor.

The steps leading to the proper values of IN and RN. Preliminary steps:

1.             Remove that portion of the network across which the Norton equivalent circuit is found. 

2.             Mark the terminals of the remaining two-terminal network. 

3.             Finding RN

Calculate RN by first setting all sources to zero and then finding the resultant resistance between the two marked terminals. Since RN = RTh the procedure and value obtained using the approach described for Thevenin’s theorem will determine the proper value of RN.


4. Finding IN :

Calculate IN by first returning all the sources to their original position and then finding the short-circuit current between the marked terminals. It is the same current that would be measured by an ammeter placed between the marked terminals.

5. Draw the Norton equivalent circuit with the portion of the circuit previously removed replaced between the terminals of the equivalent circuit.

 

Problem 1: Use Norton’s theorem to determine Ω resistance for the the cur circuit shown in Figure

 

The branch containing the 10 Ω resistance is short circuited as shown in Figure

Figure (c) is equivalent to Figure (b).Hence ISC = 10/2

 

= 5A

If the 10V source of e.m.f. is removed from Figure (b) the resistance ‘looking-in’ at a break made  between A and B is given by:

 

= 2 × 8/2 + 8 = 1.6 Ω

From the Norton equivalent network shown in Figure(d) the current in the 10 Ωresistance, by current division, is given by:

 

= (1.6/1.6 + 5 + 10) (5) = 0.482A

as      obtained   previously   in   problem   7   using   Thévenin’s theorem.


 

Problem 2: Problem 2: Use Norton’s theorem to determine the current I flowing in the 4 Ω resistance shown in Figure (a).


The 4 Ωbranch is short-circuited as shown in Figure (b). From Figure (b), ISC =I1 +I2 =4A

 

If the sources of e.m.f. are removed the resistance ‘looking-in’at a break made be given by:

 

= 2 × 1/2 + 1 = 2/3 Ω

From the Norton equivalent network shown in Figure (c) the current in the 4 Ωresistance is given by:

 

=(2/3/(2/3) + 4)(4) = 0.571A,

 

as obtained previously in problems 2, 5 and 9 us superposition and Thévenin.

Post a Comment

0Comments
Post a Comment (0)